Engraving machine spindle motor does not turn or reverse
Check the setting of the parameters of the 1 inverter;
The signal line 2 inverter is reversed.
Engraving machine open software startup, appear axis off
Bad contact 1 drive problems or computer output signal line;
Contact the 2 motor line.
Carving machine appeared in the process of limiting phenomenon
1 check if the engraving path exceeds engraving scope;
2 in the software parameter settings of the soft limit.
Engraving machine sending software cannot be opened normally, carving things appear deformity
1 to install the new system and software;
2 check X, Y axis screw and the screw is loose;
3 engraving tool problem.
Work in the process of engraving machine spindle motor suddenly stop or turn slow
1 working voltage instability or overload, plus a regulator can;
2 check the middle line is connected, whether there is a connecting thread.
When setting the origin of the engraving machine, sometimes forward, the right offset distance
1 limit switch failure, the system back to the system in the course of the origin of the limit switch has been closed and open, for the limit switch can be;
2 drive line loose, try to fix it.
Engraving machine to start the reset for the X axis, Y axis, Z axis position
1 limit switch is bad (the limit switch is always closed), can change;
2 drive line is bad (X axis 14 pin and 15 pin short circuit, Y axis 13 pin and 15 pin short circuit, Z axis 31 pin and 15 pin short circuit), change the drive line or short circuit can open;
3 drive plate is bad, change the drive board can.
Check the setting of the parameters of the 1 inverter;
The signal line 2 inverter is reversed.
Engraving machine open software startup, appear axis off
Bad contact 1 drive problems or computer output signal line;
Contact the 2 motor line.
Carving machine appeared in the process of limiting phenomenon
1 check if the engraving path exceeds engraving scope;
2 in the software parameter settings of the soft limit.
Engraving machine sending software cannot be opened normally, carving things appear deformity
1 to install the new system and software;
2 check X, Y axis screw and the screw is loose;
3 engraving tool problem.
Work in the process of engraving machine spindle motor suddenly stop or turn slow
1 working voltage instability or overload, plus a regulator can;
2 check the middle line is connected, whether there is a connecting thread.
When setting the origin of the engraving machine, sometimes forward, the right offset distance
1 limit switch failure, the system back to the system in the course of the origin of the limit switch has been closed and open, for the limit switch can be;
2 drive line loose, try to fix it.
Engraving machine to start the reset for the X axis, Y axis, Z axis position
1 limit switch is bad (the limit switch is always closed), can change;
2 drive line is bad (X axis 14 pin and 15 pin short circuit, Y axis 13 pin and 15 pin short circuit, Z axis 31 pin and 15 pin short circuit), change the drive line or short circuit can open;
3 drive plate is bad, change the drive board can.